Xporter/vo Gives incompatible project

BenWoestenburg · Post by **BenWoestenburg** » Mon Oct 14, 2019 12:11 pm

Hi guys,

I have tried to migrate the explorer example from Vo to X# by following the documention in Getted started. When I open de SLN in Visual Studio I get the folowing message:
This project is incompatible with the current edition of VS.

I use VS 2019, V 4.8.03752 and xPorter V 2.0.0.0

Any suggestions?

Thanks in advance.

robert · Post by **robert** » Mon Oct 14, 2019 12:35 pm

Ben,
Did you install VS 2019 after installing X#?
You can check that in the Help Menu of VS 2019. If you don't see the entry "XSharp Documentation" in that menu, then you need to rerun the installer.

Robert

BenWoestenburg · Post by **BenWoestenburg** » Mon Oct 14, 2019 12:49 pm

Robert,

I assume you mean the installer of X#. There was no Xsharp documentation so I have installed X# again but still no Xsharp documentation in the help menu.

Ben

robert · Post by **robert** » Mon Oct 14, 2019 12:52 pm

Ben,

Did you see the option to install X# into VS 2019 in the Setup program ?

Robert

BenWoestenburg · Post by **BenWoestenburg** » Tue Oct 15, 2019 9:53 am

Yes Robert, I did and it was checked.

I have tried to install X# as supervisor, with and without Xide, with or without VS 2017 but I did not get Xsharp documentation in the help-menu.

I did install the latest version VS ( community) before all this.

Ben

robert · Post by **robert** » Tue Oct 15, 2019 10:03 am

Ben,
Can you first look in VS2019 in the Extensions - Manage Extensions menu option to see if the 2 XSharp Extensions are available and ENABLED. You may have accidentally disabled these (VS Sometimes puts up a banner at the top, they call this the 'Gold Bar' and suggest to disable an extension).

Otherwise can you check the "c:Program Files (x86)XSharpUninst" folder and see if there are files:
- deployvs2019.cmd
- removevs2019.cmd
The first is used during installation to register X# with VS 2019. Could you run this from an administrator command prompt and see if there are any error messages.
There should be lines in there:
- That remove some directories
- that XCopy C:Program Files (x86)XSharpExtension*.* to the VS2019 folder
- that XCopy "C:Program Files (x86)XSharpMsBuild*.*" to another VS2019 folder
- that run the VS 2019 Devenv.exe with the /updateconfiguration commandline option

If that does not work then I'd like to have a look at you computer if that is possible.

Robert

BenWoestenburg · Post by **BenWoestenburg** » Tue Oct 15, 2019 10:32 am

Robert,

In the extentions X# was present and enabled. Executing deployvs2019.cmd on an administrator prompt did the trick. I have ported the application another time and everything sames to be ok.

Thanks for your help.

Ben

Main menu